Campbell CR300 Series Operator's Manual page 23

Add measurements to the table by
selecting them under Selected
Sensors and then clicking on an
output processing option in the
center column of buttons.
Select BattV under Selected Sensors and then click Average. Repeat this procedure for PTemp_C and Temp_C.
Click Finish to compile the
program. Give the program a name.
A summary screen will appear
showing the compiler results. Any
errors during compiling will be
displayed.
Give the program the name MyTemperature. Save it in the default C:\CampbellSci\SCWin folder. Do not send the
program at this time.
If LoggerNet, PC400, or PC200W is
running on your PC, and the PC-to-
datalogger connection is active, you
can choose to send the program. See
Section 4.1, Configure Software
, for setting up an active PC-to-
3)
datalogger connection with
datalogger support software.
Click No. Do not send the program here. You will do this in Section 4.5, Send a Program
(p.
CR300-Series Datalogger
.
(p. 14)
13