Create A Program - Campbell CR300 Series Operator's Manual

In the Table Monitor, select a data
table in the Table Monitor list. The
table is now displayed. Each table
will update as described in Section
.
5.6, Monitoring Data
(p. 23)
View the Public table by selecting the Public table in the Table Monitor list.
Click Disconnect to end the session.
4.3

Create a Program

Open Short Cut.
LoggerNet:
From the LoggerNet toolbar, click
Program | Short Cut.
Select New Program.
Short Cut is an easy way to program your CR300 datalogger to measure
sensors. Short Cut is included in installations of LoggerNet. It is also available
as a download on www.campbellsci.com
This section will guide you through programming a CR300-Series datalogger
to measure the voltage of the CR300 power supply, the internal temperature of
the CR300, and the ambient air temperature using a thermocouple. With minor
changes, these steps can apply to other measurements.
Watch the video for Sections 4.3 – 4.4:
CR300-Series Datalogger
and the ResourceDVD.
CR300 QuickStart Part 3.
9