Campbell CR300 Series Operator's Manual page 16

CR300-Series Datalogger
The CR300 ships with a default
program called QuickStart.CR300.
If your CR300 is running another
program, the program name will
show in the Current Program
field.
If the current program is not QuickStart.CR300, visit www.campbellsci.com/start/cr300, where the program can be
downloaded.
Click Select and Send Program... Select the downloaded program QuickStart.CR300, and click Open. A status bar
will appear while the program is sent to the CR300, followed by a confirmation that the transfer was successful.
Click OK to close the confirmation.
Click Next.
LoggerNet only:
The Data Files window shows the
data tables available on the CR300
and allows you to select which data
tables to collect. To include a table
in data collection (Section 4.6,
Collect Data ), highlight the
(p. 15)
table name in the Tables list and
check the Table Collected During
Data Collection box. Select a Data
File Option suitable for your
application. Make note of the
Output File Name. Change this
name by clicking .
Keep all default settings.
Click Next.
LoggerNet only:
Optional: In the Scheduled
Collection window, check
Scheduled Collection Enabled to
have LoggerNet collect data from
the datalogger according to a
schedule. Set the Base Date and
Time at which you would like to
begin scheduled collections. Enter
the Collection Interval.
6