Table Of Contents - Campbell CR300 Series Operator's Manual

Table of Contents

PDF viewers: These page numbers refer to the printed version of this document. Use the
PDF reader bookmarks tab for links to specific sections.
1. Introduction ................................................................ 1
2. Precautions ................................................................ 1
3. Initial Inspection ......................................................... 2
4. QuickStart ................................................................... 2
5. Overview ................................................................... 20
6. Details ....................................................................... 26
4.1 Configure Software .............................................................................. 3
4.2 Connect to the CR300 .......................................................................... 7
4.2.1 Connect with PC200W or PC400 ................................................. 7
4.2.2 Connect with LoggerNet ............................................................... 8
4.3 Create a Program .................................................................................. 9
4.4 Wire Sensors and Devices .................................................................. 14
4.5 Send a Program .................................................................................. 14
4.6 Collect Data ....................................................................................... 15
4.6.1 Collect Data with PC200W or PC400 ......................................... 15
4.6.2 Collect Data with LoggerNet ...................................................... 17
4.7 View Data .......................................................................................... 18
4.8 Install the CR300 ............................................................................... 18
4.9 Apply Power ...................................................................................... 19
4.10 Connect to Earth Ground ................................................................... 19
5.1 Wiring Panel Overview ...................................................................... 20
5.2 Configuring the CR300 ...................................................................... 21
5.2.1 Device Configuration Utility ....................................................... 21
5.2.2 Network Planner ......................................................................... 21
5.3 Configuring Datalogger Support Software ........................................ 22
5.4 Writing a Program .............................................................................. 22
5.5 Sending a Program ............................................................................. 22
5.6 Monitoring Data ................................................................................. 23
5.7 Collecting Data .................................................................................. 23
5.8 Viewing Data ..................................................................................... 23
6.1 Analog Measurements ........................................................................ 26
6.1.1 Voltage Measurements - Details ................................................ 26
6.1.1.1 Single-Ended Measurements ............................................ 26
6.1.1.2 Differential Measurements ............................................... 27
6.1.1.3 Voltage Ranges ................................................................ 27
6.1.1.4 Settling Time .................................................................... 27
6.1.1.5 Reverse Differential ......................................................... 27
6.1.1.6 First Notch Frequency ...................................................... 27
6.1.2 Resistance Measurements - Details ............................................ 28
6.1.2.1 Voltage Excitation ............................................................ 30
i