Wire Sensors And Devices; Send A Program; Opening A Terminal - Campbell CR300 Series Operator's Manual

CR300-Series Datalogger
4.4

Wire Sensors and Devices

4.5

Send a Program

Connect to the datalogger as shown
in Section 4.2, Connect to the
CR300 .
(p. 7)
The Current Program section
shows the program currently
running on the CR300. Click Send
New or Send Program... to send a
new program to the datalogger.
Select the program to send, and
click Open.
Send the program created in Section 4.3, Create a Program
Select MyTemperature.CR300 file. Click Open.
14
If the program was created in Short Cut, follow the wiring diagram created by
Short Cut to attach sensors and devices to the datalogger. The wiring must
match the diagram exactly for the sensors to be measured correctly.
If the program was created directly in the CRBasic Editor, attach sensors and
devices according to the options chosen for the measurement instructions and
according to their individual product manuals.
To open a terminal on the CR300, use the included flat-blade screwdriver. This
is shown in FIGURE 4-1 below.
FIGURE 4-1. Opening a Terminal
Watch the video for Sections 4.5 – 4.7:
(p. 9)
CR300 QuickStart Part
. Browse to the C:\Campbellsci\SCWin folder.
4.