Christie DHD630-GS Installation Manual page 10

Mounting the lens support bracket
To provide additional support for the ultra short throw lens, mount it on a support bracket.
1. Place the ultra short throw lens on a cushioned surface to prevent damaging the lens.
2. Using two M3x8 screws, secure the lens bracket to the ultra short throw lens.
Note the direction of the arrow on the lens bracket.
3. Place the projector upside-down on a flat, clean surface.
4. For 630-GS and 635-GS only, to ensure enough clearance exists between the lens support
bracket and the surface the projector is on, rotate each projector foot five counterclockwise
turns.
5. Align the mounting block to the lens support bracket.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
10