Christie DHD630-GS Installation Manual page 14

c) To fasten the two rear pillars of Christie One Mount to the projector, install the two M3x8
hex screws (no washers required) provided with Christie One Mount.
d) Fasten the two front pillars of Christie One Mount to the lens support bracket assembly.
• For the 700-GS, 850-GS, 880-GS, 1075-GS, 1100-GS, and 1400-GS models, install
the two M6x65 screws and two M6 washers.
• For the 630-GS and 635-GS models, install two M6x55 screws.
11. Turn the projector back to its original orientation.
12. Install the three extension rods.
• For LSM1, face the socket heads of the extenders towards the projector.
• For LSM2, face the red rubber rings on the extenders toward the projector.
The boresight extensions rods must be installed before installing the ultra short throw lens.
LSM1:
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
14