Christie DHD630-GS Installation Manual page 7

Installing the ultra short throw boresight adapter
plate for LSM1
Install the boresight adapter plate for LSM1.
1. Disconnect the connector from the plate the boresight adapter rests on.
If in a poorly lit area, stand the projector with the projector aperture facing up for better
visibility of the connector.
2. Insert the new ultra short throw lens boresight adapter in the projector.
When inserting the new boresight adapter, make sure it does not scratch the aperture casing
of the projector and the cable is not wrapped or pinched.
3. Install and tighten the three screws.
4. Install the connector you disconnected in step 1 on the new boresight adapter plate.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
7