Christie DHD630-GS Installation Manual page 9

• Turning the screw counter-clockwise moves the circuit board towards the screw.
• Turning the screw clockwise moves the circuit board away from the screw.
The middle screw in the pogo pin adapter must be turned at least three counterclockwise turns or the
pogo pin adapter cannot be properly installed in the projector.
1. Insert the UST lens pogo pin adapter into the projector.
Before installing the pogo pin adapter, make sure the middle screw on the adapter is turned
counter-clockwise for at least three turns and the other two screws are loosened.
2. Tighten the side screws (B) on the pogo pin adapter.
3. Tighten the middle screw (C) on the pogo pin adapter.
Make sure you tighten the side screws before tightening the middle screw.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
9