Christie DHD630-GS Installation Manual page 12

8. For the 630-GS and 635-GS models only, install the rubber spacer provided in the installation
kit on top of the default rubber spacer on the lens support bracket.
The additional rubber spacer is not required for the 700-GS, 850-GS, 880-GS, 1075-GS, 1100-
GS, and 1400-GS models.
9. If not mounting the projector using Christie One Mount, complete the following steps:
a) Attach the lens support bracket assembly to the bottom surface of the projector.
b) Install the two M6x22 hex screws and two M6 washers in the mounting holes of the
projector.
700-GS, 850-GS, 880-GS, 1075-GS, 1100-GS, and 1400-GS:
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
12