Christie DHD630-GS Installation Manual page 24

5. Remove the lens through the front of the projector.
6. 6. If installing a non-ultra short throw lens in the projector:
a) Remove the new boresight adapter and install the original standard boresight adapter.
Repeat the steps in the Removing the standard boresight adapter plate (on page 5) in
reverse order.
b) Install a non-ulra short throw lens.
c) From the on-screen display, do one of the following:
• For the 700-GS, 850-GS, 1075-GS, 880-GS, 1100-GS, and 1400-GS models, select
Configuration > Service.
• For the 630-GS and 635-GS models, select Settings > Service.
d) Enter the Service password.
e) Select OK.
f) For the 630-GS, 635-GS, 700-GS, 850-GS, and 1075-GS, models, select UST Lens
Install > None.
A lens calibration is performed and the projector is ready to use with the non-ultra short
throw lens.
g) For the 880-GS, 1100-GS, and 1400-GS models, select UST > Off.
A lens calibration is performed and the projector is ready to use with the non-ultra short
throw lens.
Ultra Short Throw Lens Installation Instruction Sheet
020-102569-07 Rev. 1 (12-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Ultra short throw lens installation
24