To Update Firmware - HP 16600A Series User Manual

1 End any run control sessions which may be running.
2 In the Workspace window, remove any Emulator icons from the
3 Install the firmware onto the logic analysis system's hard disk, if
4 In the system window, click the emulation module and select
5 In the Update Firmware window, select the firmware version to
6 Click
See Also
Chapter 6: Connecting and Configuring the Emulation Module

To update firmware

To update firmware
After you have connected the emulation module to your target system,
you may need to update the firmware to give it the right "personality"
for your processor. You must update the firmware if:
• The emulation module is being connected to a new analysis probe or TIM,
or
• The emulation module was not shipped already installed in the logic
analysis system, or
• You have an updated version of the firmware from HP.
To update the firmware:
workspace.
necessary.
Update Firmware
load into the emulation module.
Update Firmware
In about 20 seconds, the firmware will be installed and the screen will
update to show the current firmware version.
Chapter 2, "Installing Software," beginning on page 29, for instructions
on how to install the firmware files on the hard disk.
144
.
.
Solutions for CPU32