HP 16600A Series User Manual page 187

Chapter 8: Using the Emulator with a Debugger
Using the Green Hills debugger
• In the Builder window, click Debug to open the Debugger window, then in
the Debugger window's command pane, enter:
remote hpserv IP_address
Starting hpserv opens two windows: the Target window and the I/O
window. Commands entered in the Target window are sent directly to
the emulation module.
The I/O window sends input (stdin) to and receives output (stdout)
from the target program while it is running.
Note that hpserv connects to the first emulation module (port 6470) in
a logic analysis system frame. You may specify another port by using
the -p option with hpserv. See page 178 for more information on port
numbers.
4 Start the debugger.
If you have not opened the Debugger window yet, click Debug in the
Builder window.
5 Configure the emulation module and target system.
Before running the target processor, you must configure the HP
emulation module for your target system. For example, you may have
to set the BDM clock speed, the reset operation, cache disabling, or
other configuration parameters.
If you are unsure of the configuration needed for your emulation
module, you can use the Configuration window in the logic analysis
system's Emulation Control Interface to explore the configuration
options.
Once you know the configuration settings needed for your target
system, you may use one of the following methods to configure the
emulation module and target system:
• Use the Configuration window in the logic analysis system's Emulation
Control Interface.
• Enter "cf" commands in the Target window.
• Use an initialization script.
See "To configure the emulation module, analysis probe, and target using
an initialization script" on page 188 for information on saving the
186 Solutions for CPU32