HP 16600A Series User Manual page 278

1 Disconnect the 50-pin cable from the emulation module, and plug
2 telnet to the emulation module.
3 Enter the pv 1 command.
See Also
To run complete performance verification tests
using a telnet connection
the loopback test board (HP part number E3496-66502) directly
into the emulation module. Do not plug anything into the other
end of the loopback test board.
On a good system, the RESET LED will light and the BKG and USER
LEDs will be out.
Options available for the "pv" command are explained in the help
screen displayed by typing "help pv" or "? pv" at the prompt. Note,
however, that some of the options listed may not apply to your
Solutions for CPU32
Chapter 13: Troubleshooting the Emulation Module
Problems with the Emulation Module
277