HP 16600A Series User Manual page 186

follow these steps:
a Prepare the executable.
Go to the 68000PC subdirectory where you installed MULTI. Copy the
default.lnk file to user.lnk.
b Start MULTI.
On Unix, enter "multi".
On Windows, double-click the Green Hills icon.
c Set up the MULTI software environment:
• Replace the project default.bld (in the Builder dialog box next to the
project button) with hpdemo/ecs.bld and press ENTER.
• Make sure the target button on the MULTI window says "cross 68".
• In the Builder window, double-click ecs.bld.
The box next to the Debug button should display "ecs". The window should
list the names of the source code files.
d In the Builder menu bar, select
processor type.
e In the Builder menu bar, select
select the default output mode.
f Build the demo program:
• In the Builder window, click the Build icon. (Or, in the menu bar, select
Build©Build All
• Close the Progress window when the "Build completed" message is
displayed.
g Select
Options©Advanced
mode to generate an IEEE-695 format file.
3 Connect MULTI to the emulation module.
There are two ways to connect to the emulation module:
• In the Remote box in the MULTI Builder window, enter:
hpserv IP_address
OR
Solutions for CPU32
Chapter 8: Using the Emulator with a Debugger
Options©CPU
Options©Advanced
.)
, and select the IEEE-695 output
Using the Green Hills debugger
, then set the
, and
185