See Also
1 Connect a telnet session to the emulation module over the LAN.
2 Enter
3 Use the
See Also
Chapter 6: Connecting and Configuring the Emulation Module
Configuring the Emulation Module
Help©Help on this window in the Configuration window for
information on each of the configuration options.
Help in the Emulation Control Interface menu for help on starting an
Emulation Control session.
To configure using the built-in commands
If you are unable to configure the emulation module with the
Emulation Control Interface or a debugger interface, you can configure
the emulation module using the built-in "terminal interface"
commands.
For example, on a UNIX system, for an emulation module in Slot 1
enter:
telnet LAN_address 6472
to see the current configuration settings.
cf
command to change the configuration settings.
cf
Enter help cf for help on the configuration commands.
For information on connecting using telnet, and for information on
other built-in commands, see page 269.
148
Solutions for CPU32