Table of Contents
Advertisement
3.5.5
Installing an hard disk
To install an hard disk:
1. Carefully connect the disk to the IDE connector.
2. Screw the four screws at the bottom of the board to fix it to the board.
3. Boot the AT8001 and make sure the drive is detected by the BIOS setup.
- This feature is only available when you don't a have a AMC
- You cannot have an hard disk and a AMC at the same time
3.5.6
Installing a CompactFlash
This product supports all type I CompactFlash modules.
Never install or remove the compact flash while the board is on.
To install the CompactFlash:
1. Insert the CompactFlash in place (J21).
2. Close the retention clip on it.
To remove the CompactFlash:
1. Open the retention clip.
2. Pull the CompactFlash module out.
WARNING
WARNING
3-9
AT8001 User's Guide
Advertisement
Table of Contents
