Table of Contents
Advertisement
2.17.4
Lamp Test
The lamp test does the sequence shown below in the order 1-2-3-4-1-2-3- etc. Step 4 is not
displayed when the regional bit is set for Europe (no red allowed). The lamp test can be initiated by
software (IPMC) or just by pressing the reset pushbutton long enough.
LED arangement and face plate finish may vary depending on board configuration.
#1
No LEDs
2.17.5
IPMI controlled LED
The green Management LED represent when pulsing acommunication between Host Interface and
IPMC
The green Management LED represent the IPMC heart beat when it blink slowly
The amber Management LED represent IPMC communication over IPMB-0 when pulsing
#2
All green & blue LEDs
2-38
#3
All amber LEDs
#4
All red LEDs
AT8001 User's Guide
Advertisement
Table of Contents
