Summary of Contents for Kontron 820951 ADD2-DVI-Dual-Internal
Page 1
User Manual Date: 2008-11-25 Page 1 of 9 User Manual for the Add-On cards: 820951 ADD2-DVI-Dual-Internal 820952 ADD2-DVI-Dual 820955 ADD2-DVI-Dual-Internal-C01 820958 ADD2-DVI-Dual-Internal-150 AGP Digital Display second generation card with Dual DVI transmitters Designed primarily for 986LCD-M family and KT965/Flex motherboards.
Page 2
Brand and product names are trademarks or registered trademarks of their respective owners. Disclaimer: KONTRON Technology A/S reserves the right to make changes, without notice, to any product, including circuits and/or software described or contained in this manual in order to improve design and/or performance.
Page 3
KONTRON Technology Technical Support and Services If you have questions about installing or using your KONTRON Technology Product, check this User’s Manual first – you will find answers to most questions here. To obtain support, please contact your local Distributor or Field Application Engineer (FAE).
PCI-Expressx16 connector SDVO Motherboard with multiplexed PCI-Expressx16/SDVO connector Note that VBIOS located in I2C is not used as default. The reason is that the BIOS used in the Kontron Motherboards of 986LCD-M and KT965 families are supporting the ADD2-DVI card directly.
820955 includes two 821524 ADD2-DVI Aux Cable 300mm 820958 includes two 1022-2966 ADD2-DVI Aux Cable 150mm Example: 820951 ADD2-DVI-Dual-Internal with cables mounted. The 821524 and 1022-2966 cable kits are based on two pieces of Hirose DF19L-20P-1H connector. The wiring is a one-to-one connection. The cable kit includes a DVI-SIL to DVI-I converter module.
ADD2-DVI-Dual KTD-00714-F Public User Manual Date: 2008-11-25 Page 8 of 9 Connector Description The DVI-I connector is a Molex 74320-1004 (or similar). Only DVI Digital output is supported. (Both DVI-I and DVI-D cables can be connected). Pin No. Signal Type Pull Up C1 C2 TMDS Data 2-...
ADD2-DVI-Dual KTD-00714-F Public User Manual Date: 2008-11-25 Page 9 of 9 Jumper Description (unsupported) The Jumpers (only available on the ADD2-DVI-Dual-Internal) are used to configure one or both DVI outputs for TMDS or PanelLink panels where DDC (EDID codes) are not integrated. By use of jumpers it is possible to connect onboard EEPROM to the DDC channel and to select panel to be always connected.