Nortel DMS-100 Series Maintenance Manual page 124

5-10 RLCM-EDC alarm clearing procedures
PM LCM
critical
(continued)
18
19
297-8381-550 Standard 02.02 April 1999
To post the host LTC+ links and check link conditions for slips and framing
errors, type
>POST LTC ltc_no link_no
and press the Enter key.
where
ltc_no is the number of the LTC+ (0 to 255)
link_no is the number of the link associated with the host XPM (see
step 16 display)
Note: Repeat the POST command for each link supplied for the RLCM-EDC.
Example of a MAP response:
N CLASS SITE LTC CK D ALRM SLIP FRME
0 REMOTE HOST
Note: This display shows carrier facilities from the host LTC+ to the
RLCM-EDC. Use the Detail REM option to check the carrier facilities from the
remote site back to the host LTD+.
If link conditions
indicate a high number of SLIP
and FRME
indicate a very low number of SLIP
and FRME
To post the RLCM-EDC with the alarm condition, type
>PM; POST LCM site cabinet lcm
and press the Enter key.
where
site is the site name of the RLCM-EDC (alphanumeric)
cabinet is the cabinet number of the RLCC-EDC
lcm is the number of the LCM
Host LTC+ P-side link number
1 0 C 0
Do
step 24
step 19
BER ES SES STATE
0 1995262 0 0 INSV