Wiring The System; Positioner Power/Data Connector; Power And Controls System Overview - Will Burt ACCUPOINT AP-8 Operator's Manual

2.6 Wiring the System

This section discusses wiring the system assuming the joystick controller is being used.
Alternative Pelco D compatible controllers can be used to control the Accupoint Positioners.
Contact the Will-Burt Technical Team if further assistance is needed.

2.6.1 Positioner Power/Data Connector

The positioner has one Power/Data Connector located on the back side of the body of the
positioner (Figure 2-5). The Power/Data Connector has two pins designated for power and 2
pins designated for data, see Section 2.6.3 for more details

2.6.2 Power and Controls System Overview

This section provides an overview of a standard 24VDC Accupoint Positioner system setup.
Examples are provided for systems with 12VDC, 24VDC and 110VAC/240VAC supplied
power. Before setting up your system verify the voltage of your positioner by checking the
serial tag located on the positioner. If you are unsure of your positioners voltage rating
contact Will-Burt Customer Service
Equipment Damage! Ensure the connections are made properly to prevent water ingress
into the positioner through the connections. Should water enter the positioner, extreme
problems can occur.
The system configuration depends on the power provided to your system. Select the
appropriate power below for your system and configure accordingly:
1. Powered with 12VDC
2. Powered with 24VDC
2-32
Figure 2-5 Positioner Power/Data Connector Location
Accupoint Positioners
Power/ Data
Connector
PM-01010-REV 2
May 2022