Directions; Symbols - Will Burt ACCUPOINT AP-8 Operator's Manual


"Stowed" refers to a customer-set preset position whereby the positioner moves the
payload to a desired pan and tilt position for travel or safe storage. Preset [1] is
designated as the "Stowed" position.

"Unstowed" refers to a customer-set preset position whereby the positioner moves
the payload to a desired pan and tilt position from the stowed position. The customer
should be sure the positioner can be safely moved to this position from the stowed
position without causing damage. Preset [2] is designated as the "Unstowed"
position.

1.4.1.3 Directions


When operating the positioner, directions are given as follows:
Left
Power/ Data
Connector
Rear View

When using the joystick controller:
o Pushing the joystick forward will tilt the positioner towards the rear
o Pulling the joystick back will tilt the positioner towards the front
o Moving the joystick to the right will rotate the positioner clockwise
o Moving the joystick to the left will rotate the positioner counterclockwise

1.4.1.4 Symbols:


Characters inside < > as in <Success!> represent text that appears on the display
screen.

Characters inside [ ] as in [1] represent buttons or keys being used.

Arrows as in "▲, ►, ▼, ◄" represent the direction(s) the positioner is moving in.
These arrows are shown on the display screen of the joystick controller.
PM-01010-REV 2
May 2022
Right
Left
Rotate Clockwise
Towards Right
Figure 1-2 Positioner Directions
Accupoint Positioners
Move Up from Front
Front
Rear (Side with
Connector)
Move Down to Front
Aerial View
Right
Rotate
Counterclockwise
Towards Left
1-11