Table of Contents
Advertisement
Section 2
This section describes the installation of the system and provides general procedures that
must be followed to ensure a successful installation.
2.1 Pre-Installation Check
Before installing the system:
Be sure to read and understand the entire installation procedure before beginning
installation.
Ensure that only a properly trained and qualified certified electrician performs electric
installations and maintenance.
Ensure that all required tools are readily available.
Ensure that the following warnings are understood and followed:
Mounting Structure Hazard! Before installation, be certain the mounting structure is capable
of resisting forces generated from all loading and environmental conditions including, but not
limited to natural frequency/resonance, system size and weight, payload size and weight, sail
size, and wind speed. Mounting the system to a structure unable to resist the forces
generated from customer-specific loading scenario could result in death or serious injury and
could damage the system.
Safety Instruction – Mounting Instructions! Be sure to understand all mounting
instructions. The mounting hardware must include proper means to resist vibration loosening
such as thread-locking compound or locking hardware. Failure to follow mounting
instructions can result in death or injury.
Trained Personnel Only! Only trained and qualified personnel should perform installation,
adjustments, and servicing. Only a properly trained and qualified certified electrician should
perform electric installations and service. Death or serious injury could result if proper
installation, inspection, operation, and maintenance procedures are not observed.
Equipment Damage! Failure to follow mounting instructions can result in damage to the
positioner. For any inversion of the unit that differs from a horizontal mounting consult with
Will-Burt Engineers prior to any installation.
2-28
Installation
Accupoint Positioners
PM-01010-REV 2
May 2022
Advertisement
Table of Contents
