Wiring The System; Positioner Plugs; Figure 2-3 Positioner Plug Locations (Pi-150 Shown) - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

I P
OSITION T OSITIONERS
P

2.6 Wiring the System

This section discusses wiring the system assuming the default joystick controller (P/N:
5098901) is being used.

2.6.1 Positioner Plugs

The positioner has (2) plug locations on the mounting pedestal for wiring. The side egress
(Figure 2-3) on the mounting pedestal ships from the factory with a removable plug installed.
The bottom egress on the mounting pedestal ships from the factory with a plug plate
installed. To use the bottom egress, the plug plate and the removable plug must be
swapped. If either egress is not properly sealed, the positioner will leak and become
damaged voiding the warranty.
Removable
Plug
Side Egress with Removable Plug
(View From Side)
To use the bottom egress:
1. Ensure there is no power to the positioner.
2. Loosen the (4) bolts securing the removable plug to the side of the mounting
pedestal.
2-4

Figure 2-3 Positioner Plug Locations (PI-150 Shown)

Plug
Plate
Bottom Egress with Plug Plate
(View From Beneath)
PM-01011-A
October 2023