Quick Overview; To Install The Positioner (Section 2); To Operate The Positioner (Section 3) - Will Burt ACCUPOINT AP-8 Operator's Manual

1.7 Quick Overview

This section provides a quick overview of the system. Be aware of and follow all associated
precautions when performing these procedures.

1.7.1.1 To install the positioner (Section 2):

1. Mount the positioner using the appropriate hardware (see Section 2.5).
2. Wire the positioner according to the schematic (see Section 2.6).
3. Mount the payload with appropriate hardware (see Section 2.7).

1.7.1.2 To operate the positioner (Section 3):

1. Connect the controller.
2. Operate the positioner using a controller (see Section 3).
3. If required, see Section 3.4.3.4 for information on how to adjust the electronic limit
stops. The positioner ships from the factory with electronic limit stops set. There are
no hard limit stops.
4. If required, see Section 3.4.3.7 for information on how to use preset positions.
PM-01010-REV 2
May 2022
Accupoint Positioners
1-27