Stow And Unstow Operation; Unstowing The Positioner; Stowing The Positioner - Will Burt ACCUPOINT AP-8 Operator's Manual

3.6 Stow and Unstow Operation

3.6.1.1 Unstowing the Positioner

The Preset [2] position is designated as the "Unstowed" position. The user must Set Preset
[2] using the joystick controller, rack mount controller or a GUI as described above before
this function can be used.
To unstow the positioner:
1. Power on the system.
2. Perform the pre-operation check see Section 3.1
3. Press [2].
4. Press [Pre]. The positioner will move to the preset unstowed position. As the
positioner nears the unstowed position, it will slow down. If an emergency stop is
required as the positioner is moving to its position, move the joystick to cancel out the
command.

3.6.1.2 Stowing the Positioner

The Preset [1] position is designated as the "Stowed" position. The user must Set Preset [1]
using the joystick controller, rack mount controller or a GUI before this function can be used.
To stow the positioner:
1. Perform the pre-operation check see Section 3.1
2. Press [1].
3. Press [Pre]. The positioner will move to the preset stowed position. As the positioner
nears the stowed position, it will slow down. If an emergency stop is required as the
positioner is moving to its position, move the joystick to cancel out the command.
4. Power down the system.
3-50
Accupoint Positioners
PM-01010-REV 2
May 2022