Presets - Will Burt ACCUPOINT AP-8 Operator's Manual

Set Preset [N]
70
71
72
73

3.4.3.7 Presets

Preset positions can be stored to a preset number between [1] and [50].
The controller comes from the factory with the preset [0] (zero) set to move the positioner to
the Factory Home position (mid-point of both the pan and tilt). In this position the tilt platform
will be horizontal, and the pan axis will be in the center position. This is referred to as the
"Factory Home" position.
Preset [1] is designated for the "Stow" position.
Preset [2] is designated for the "Unstow" position.
Presets can be set or called using the keyboard keys or through menu functions. Presets
can only be cleared through menu functions. It is possible to overwrite presets through either
method.
Setting Presets with the Keyboard
To store a preset position using the keyboard:
1. Use the joystick to drive the positioner to the desired position for the preset.
2. Press [Set].
3. Press [N] where "N" represents the number being assigned to the preset position.
4. Press [Pre]. The preset position is stored.
PM-01010-REV 2
May 2022
Table 3-3 Default Limit Stop Numbers
Function
Clears Left (Counterclockwise) Limit
Clears Right (Clockwise) Limit
Clears Up Limit
Clears Down Limit
Accupoint Positioners
3-47