User Supplied Controller; Major Components; Positioner - Will Burt ACCUPOINT AP-8 Operator's Manual

1.5.2.3 User Supplied Controller

The Accupoint Positioners can be controlled using any Pelco D compatible controller over an
RS485 data line that supports the appropriate command sets (ie; tilt, pan, etc.). See Section
3.4.3.9 and Section 6.3 for further details and a list of supported Pelco D commands.

1.6 Major Components

The typical major components of a positioner system are:


Positioner


Payload Platform & Base Mounting Ring (Provided with Positioner)

Controller

Power/Data Connector (Provided with Positioner)

Power/Data Cable (optional)

Positioner Power Supply (optional)

Step Up Converter (optional)

Step Down Converter (optional)
1.6.1 Positioner
Accupoint Positioners:

Are made of die-cast aluminum casing

Use stainless steel fasteners

Are designed and tested to an IP68 ingress protection rating

Are designed to minimize backlash

Are configured to run on RS485 data using Pelco D protocol, other protocols
available on request

Ship with the Accupoint Positioner Operator's Manual (this manual)
PM-01010-REV 2
May 2022
Accupoint Positioners
1-21