Panel Mount Controller Assembly (Optional) - Will Burt ACCUPOINT AP-8 Operator's Manual

6.2 Panel Mount Controller Assembly (optional)

Will-Burt offers an optional panel mount controller assembly (P/N: 4270601) for the
positioner. The panel mount controller assembly requires the communications bridge board
interface (P/N: 5090411) (section 6.1). Electronic limit stops cannot be programmed using a
Pelco D compatible joystick controller or a GUI.
The membrane controller operates as follows:

The (4) PAN/TILT arrow buttons pan the positioner left (◄) and right (►) and tilt the
positioner up (▲) and down (▼).

STOW moves the positioner into the stowed position.

UNSTOW moves the positioner into the unstowed position.
The following buttons are not used:

HIGH SPEED

LOW SPEED

MAST UP

MAST DOWN
6-56
Figure 6-2 Panel Mount Controller (P/N: 4270601)
Accupoint Positioners
PM-01010-REV 2
May 2022