Tenda N300 Wi-Fi xPON ONT User Manual page 99

Parameter Description
End IP Address
It specifies the protocol adopted by the traffic, or the types of traffic.
TELNET: Telnet is a protocol that provides a command line interface for communication
⚫
with a remote device or server, sometimes employed for remote management but also
for initial device setup like network hardware.
HTTP: Hypertext Transfer Protocol (HTTP) is an application protocol and the foundation
⚫
of data communication for the World Wide Web, where hypertext documents include
ServiceName
hyperlinks to other resources that the user can easily access.
HTTPS: Hypertext Transfer Protocol Secure (HTTPS) is an extension of HTTP. SNMP is
⚫
used for secure communication over a computer network, and is widely used on the
Internet.
PING: Ping is a computer network administration software utility used to test the
⚫
reachability of a host on an IP network.
WAN
It specifies the interface to which the rule applies. It changes as you choose an interface.
LAN
ACL Table It displays all the ACL rules that are added.
Select It is used to select multiple ACL rules.
It specifies the control mode of the rule. If you deselect Enable when setting an ACL rule,
State
the State shows Disable.
Interface It specifies the interface that the access control rule applies to, including LAN and WAN.
IP Address It specifies the IP address range or a certain IP address that is controlled by the rule.
Services It specifies the protocols adopted by the traffic, or the types of traffic.
Port It specifies the default ports adopted by the corresponding services.
91
Admin