Tenda N300 Wi-Fi xPON ONT User Manual page 43

Parameter description
Parameter
Address Mode
Request Options
IPv6 Address
IPv6 Gateway
Request DNS
Primary IPv6 DNS
Secondary IPv6 DNS
PPP settings
You can configure the PPPoE parameters to access the internet in this part.
When Channel Mode is set to PPPoE, these parameters are required.
Description
It specifies how the WAN IPv6 address of the ONT is obtained, including:
Stateless DHCPv6 (SLAAC): Stateless Address Autoconfiguration (SLAAC) is a dynamic
⚫
allocation method of IPv6 address, which enables the ONT to auto-generate IPv6
addresses with local information and those from the router advertisement.
Static: You need to enter parameters related to IPv6 address manually.
⚫
Stateful DHCPv6: DHCPv6 status settings are provided. The client obtains complete
⚫
IPv6 address information (including DNS server address) from the DHCPv6 server. The
gateway address is obtained through route advertisement (RA).
Auto Detect Mode: The ONT automatically generates the IPv6 addresses based on the
⚫
mode detected.
You can enable the ONT to obtain the IPv6 address and prefix as a DHCPv6 client.
It specifies the IPv6 address and prefix length provided by your ISP when you select
Static for Address Mode.
It specifies the IPv6 gateway address of the ONT when you select Static for Address
Mode.
When Request DNS is set to Enable, the ONT obtains the IPv6 DNS server address from
the DHCPv6 server.
When Request DNS is set to Disable, you need to set the primary and secondary DNS
server addresses manually.
35
WAN