Tenda N300 Wi-Fi xPON ONT User Manual page 65

Parameter description
Parameter Description
Outgoing Default
They specify the default action for the outgoing (LAN WAN) or incoming (WAN LAN)
Action
data.
⚫
Incoming Default
Action
⚫
Direction It specifies the forwarding direction of data to be filtered.
It specifies the protocol adopted by packets to be filtered.
⚫
⚫
Protocol
⚫
⚫
⚫
It specifies whether to deny or allow the data to pass through.
⚫
Rule Action
⚫
It specifies the source IP address of the packets. The settings of Source IP Address and
Subnet Mask determine which computers are affected by this rule.
⚫
Source IP Address
⚫
⚫
Deny: Denies traffic which does not match the filter rule in the Current Filter Table.
Allow: Allows traffic which does not match the filter rule in the Current Filter Table.
TCP: TCP protocol.
UDP: UDP protocol.
ICMP: ICMP protocol.
TCP/UDP: TCP protocol and UDP protocol.
ANY: Any protocol.
Deny: Packets that comply with the rule are denied, while others are treated with the
default action.
Allow: Only packets that comply with the rule are allowed, while others are treated
with the default action.
When Direction is set to Outgoing, this parameter specifies the LAN computer's IP
address to be affected.
When Direction is set to Incoming, this parameter specifies the internet computer's IP
address to be affected.
When this parameter is left blank, all IP addresses are covered.
57
Services