Tenda N300 Wi-Fi xPON ONT User Manual page 10

LED indicator Color
WLAN Green
◼
Ports & buttons
Port/Button
WPS/RST
PON
LAN1-GE/LAN2
PWR
Status Description
No Ethernet device is connected or the Ethernet device is not
Off
connected to any LAN port properly.
The Wi-Fi network is enabled, but no data is being transmitted
Solid on
wirelessly.
Blinking
The Wi-Fi network is enabled, and data is being transmitted
slowly
wirelessly.
(0.5s)
Blinking
quickly The ONT is performing or pending for WPS negotiation.
(0.25s)
Off The Wi-Fi network is disabled.
Description
WPS/Reset button.
WPS: Wi-Fi-enabled devices can connect to the Wi-Fi networks of the ONT
⚫
without entering the password through WPS negotiation.
Press the button for 1 to 3 seconds to start the WPS negotiation process of the
ONT. The WLAN LED indicator blink quickly. Within 2 minutes, enable the WPS
function on a WPS-supported device to establish a WPS connection.
Reset: Restore the ONT to the configurations preset by the ISP.
⚫
After the ONT completes startup, press the button for more than 10 seconds
and release it. All LED indicators will light off in a few seconds. When the PWR
LED indicator lights solid on again, the ONT is restored to the configurations
preset by the ISP.
Optical fiber port.
Used to connect to a fiber cord.
LAN1-GE: 1000 Mbps LAN port
LAN2: 100 Mbps LAN port
Used to connect to a router, switch, computer or IPTV set-top box.
Power jack.
Please use the included power adapter to connect the ONT to a power source.
2
Get to know your device