Step 6: Install The Front Door On A Ptx5000; Step 7: Connect External Devices And Pic Cables To The Ptx5000; Connect To A Console Or Auxiliary Device - Juniper PTX5000 Quick Start Manual

Step 6: Install the Front Door on a PTX5000

Optionally, you can install a door over the front card cage of the PTX5000. For more information, see the
following documentation:
Installing the Front Door on a PTX5000 in a Four-Post Rack
Installing the Front Door on a PTX5000 in an Open-Frame Rack
Step 7: Connect External Devices and PIC Cables to
the PTX5000
IN THIS SECTION

Connect to a Console or Auxiliary Device | 19

Connect to a Network for Out-of-Band Management | 21
Connect the PIC Cables | 22
To connect external devices and PIC cables, perform the following procedures:
Connect to a Console or Auxiliary Device
Attach one or more management console or auxiliary devices to the Routing Engine ports on each Control
Board for management and service operations (see
To connect the cables to a management console or auxiliary device:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. If necessary, turn off the power to the console or auxiliary device.
Figure 9 on page 20).
19