Table of Contents
Advertisement
NetPing server room environmental monitoring solutions and IP power distribution units.
[ENG] 3.1. [DKSF 48.5 IU] How to Set up a Hostname, a Location and the Contacts of the Device?
To configure a name and a location of a device as well as its contacts, there is a need to go to the page «
In the section «
Device Identification
Device Hostname – is a domain name of a device. It allows distinguishing among several NetPing devices of the same type according to a name.
A name is represented on the homepage and in the heading of a web interface, in an e-mail notification in the field «From:», in other notifications
and available via SNMP – sysName. On default: empty line
Device Location
–
is a description of a place of installation of a Netping device. It is displayed on the home page and in the heading of a web
interface, is available via SNMP – sysLocation.
Contact – is the administrator's contacts (usually, an e-mail). This information is available via SNMP – sysContact.
After configuring all necessary parameters, click the button «
In addition, it is possible to configure these parameters using an
OID
Name
.1.3.6.1.2.1.1.5.0 sysName
.1.3.6.1.2.1.1.6.0 sysLocation DISPLAYSTRING (SIZE (0..255)) READ/WRITE A location of a device.
.1.3.6.1.2.1.1.4.0 sysContact
Copyright © NetPing east Co., Ltd / E-mail:
» it is possible to configure:
On default
: empty row
Apply changes
Type
DISPLAYSTRING (SIZE (0..255)) READ/WRITE A domain name of a device.
DISPLAYSTRING (SIZE (0..255)) READ/WRITE Contacts.
support@netpingdevice.com www.netpingdevice.com
».
SNMP v1
protocol by setting OID values using the command
Access
Description
/
/ Phone: +886-2-23121582
Setup
» of a web interface of a device:
On default
: empty row
Set
:
Advertisement
Table of Contents
