Table of Contents
Advertisement
NetPing server room environmental monitoring solutions and IP power distribution units.
Timer/Counter 1...4
The control of a built-in timer/counter
IO line 1...4
The control of IO line
IR 1...4
Send an IR command with a specified number
SNMP Setter 1...2
The sending of SNMP SET commands to the other
devices
7.
The buttons "above" / "below".
order of the rules does not affect the priority of the rules.
You should avoid conflicting rules if they can lead to an attempt to control the same output simultaneously .
8.
Apply the changes.
The "
Copyright © NetPing east Co., Ltd / E-mail:
it is not recommended to mix the functions
of timer and counter.
The buttons are used to change the position of a rule in the list. Starting with DKSF software version 48.5.3, the
Apply Changes
" button saves the programmed logic rules in the device memory.
support@netpingdevice.com www.netpingdevice.com
set from 0 (the timer
function)
reset to 0
add 1 (the counter
function)
decrease 1 (th counter
function)
off (log.0)
on (log.1)
switch
impulse
send a command
off
on
/
/ Phone: +886-2-23121582
Start the timer from 0. The countdown is
carried out in seconds with a resolution of 0 ...
1sec.
Stop and reset the timer. Reset counter.
Add 1 (increment) to the current counter
value.
Decrease 1 (decrement) from the current
counter value. The counter value does not
decrease below zero.
Set the line to log.0 state.
Set the line to log.1 state.
Switch log. state of the line
To send an impulse to the line. Duration is set
in the settings of the IO line.
Play the command with the specified number
recorded in the memory of the
IRC-TR v2
ule
Record the value corresponding to "off" to the
specified OID in Setter's settings.
Record the value corresponding to "on" to the
specified OID in Setter's settings.
mod
Advertisement
Table of Contents
