Table of Contents
Advertisement
NetPing server room environmental monitoring solutions and IP power distribution units.
[ENG] 11.5. [DKSF 48.5 IU] Recommendations
If a transceiver is stuck in a protocol as a result of a failure, noise, an operator's error or managing software failure, and reacts improperly to
incoming commands, a reset can be performed by a short-term (5 s.) switching off a transceiver from a NetPing device.
Try to avoid recording commands in electroluminescent or LED lighting. The flickering light with a frequency of operation of the electronic ballast
can decrease a quality of a recorded IR signal.
Watch avoiding any objects, particularly operator's hands, between an emitter of an IR remote and an eye of a transceiver while recording
commands.
If a recorded command works unreliably, change a location of a transceiver in relation to a controlled device. In addition, change conditions of
recording a command.
Copyright © NetPing east Co., Ltd / E-mail:
support@netpingdevice.com www.netpingdevice.com
/
«
»
/ Phone: +886-2-23121582
Advertisement
Table of Contents
