Table of Contents
Advertisement
NetPing server room environmental monitoring solutions and IP power distribution units.
[ENG] 8.4. [DKSF 48.5 IU] What is a "Schedule" and How to Configure It?
A «
Schedule
» module allows configuring a schedule according to which a relay is going to switch on and off.
To use the "
Schedule
" module, relay control must be switched to "Schedule" or "Schedule + Watchdog" mode on the "AC OUTLETS" page of the
device's web interface. To configure the "
of the built-in relays:
All module settings are carried out in a pop up dialogue:
Enable Control of Relay — activation of relay control. If the checkbox is not installed, the relay will not be controlled from the "
n default
: the checkbox is not installed.
WEEKLY SCHEDULE
A schedule for the relay control is set in the settings dialogue . For each day of the week, six intervals can be configured in which the relay will be
activated.
The interval starts from the time the relay was switched on (the "
the format "
hh:mm
" in the range of
Copyright © NetPing east Co., Ltd / E-mail:
Schedule
" module, you have to press the "
On
00:00 - 23:59
. The time should increase from left to right: in the interval, the switch-on time should come earlier
support@netpingdevice.com www.netpingdevice.com
Schedule
" button located on any of the eight control channels
" column) and ends with the time off (the "
/
/ Phone: +886-2-23121582
Schedule
" module.
Of
f" column). The time is indicated in
I
Advertisement
Table of Contents
