Table of Contents
Advertisement
NetPing server room environmental monitoring solutions and IP power distribution units.
[ENG] 14.4. [DKSF 48.5 IU] The Support of SNMP trap
A formal description of SNMP TRAP messages can be found in the
the device description page in the "Documentation and Files" section:
For NetPing 8/PWR-220
The SNMP TRAP message is sent in
The unique mutual correspondence between the identification of SNMP TRAP messages for
between Version 1, Version 2, and Version 3 of the Internet-standard Network Management Framework".
As a rule, programs for processing SNMP notifications carry out the conversion between two formats easily.
In order to send SNMP TRAP messages you have to:
specify the IP address for sending SNMP TRAP on the "
enable sending SNMP TRAP messages by switching on the corresponding checkboxes in the sensors and relays configuration dialogs.
SNMP TRAP WHEN CHANGING THE LEVEL ON THE IO LINE IN THE "IO" MODE
Identification npIoTrap
SNMP v1 enterprise
SNMP v1 generic-trap
SNMP v1 specific-trap
SNMP v2 snmpTrapOID
Valiable values in the set npIoTrap (varbind list)
OID
.1.3.6.1.4.1.25728.8900.2.1.0
.1.3.6.1.4.1.25728.8900.2.2.0
.1.3.6.1.4.1.25728.8900.2.6.0
SNMP TRAP WHEN CHANGING THE STATUS OF A TEMPERATURE SENSOR
Identification npThermoTrap
SNMP v1 enterprise
SNMP v1 generic-trap
SNMP v1 specific-trap
SNMP v2 snmpTrapOID
Variable values in the set npThermoTrap (varbind list)
OID
.1.3.6.1.4.1.25728.8800.2.1.
0
.1.3.6.1.4.1.25728.8800.2.2.
0
Copyright © NetPing east Co., Ltd / E-mail:
v4/SMS: http://www.netpingdevice.com/products/netping-8-pwr-220-v4-sms
SNMP v1
format, while the description in the MIB file has
.1.3.6.1.4.1.25728.8900.2
enterpriseSpecific(6)
1
.1.3.6.1.4.1.25728.8900.2.0.1
The type of the
data
Integer
The IO line number (starting with "1"), the change of which caused the sending of a TRAP
message
Integer
The value of the logic level on the IO line ("0" or "1")
DisplayString
The memo (textual description of the line, encoding win1251)
.1.3.6.1.4.1.25728.8800.2
enterpriseSpecific(6)
1
.1.3.6.1.4.1.25728.8800.2.0.1
The type of the
data
Integer
The number of a sensor (1...8), the change of which caused the sending of a TRAP
message
Integer
Current temperature value, °C
support@netpingdevice.com www.netpingdevice.com
DKSF 48.5.X MB
MIB file attached to the firmware. It can be downloaded on
SNMP v2c
v1
and
SETUP
" page of the device`s web-interface;
The description
The description
/
/ Phone: +886-2-23121582
format.
v2c
is described in RFC3584 "Coexistence
Advertisement
Table of Contents
