PaloAlto Networks PA-5400 Series Hardware Reference Manual page 95

Service the PA-5400 Series Firewall Hardware
Purpose
Show NC slot status.
Temporarily power on and
off an NC slot.
This command gracefully
powers off a slot and ends
current sessions. You
can use this command to
remove an NC.
Power off an NC slot.
When running this
command, the NC slot stays
powered off, even after a
reboot.
Enable a slot so the NC can
pass traffic.
Enable new NCs on
both firewalls in an HA
configuration.
PA-5400 Series Next-Gen Firewall Hardware Reference
Command
Run the following to view all of the slots:
admin@PA-5450> show chassis status
To view the status of one slot run:
admin@PA-5450> show chassis status slot <slo
t-number>
For example, to check the status of slot 1, run:
admin@PA-5450> show chassis status slot s1
To power off a slot:
admin@PA-5450> request chassis power-off slo
t <slot-number>
To power on a slot:
admin@PA-5450> request
chassis power-on slot <slot-number>
admin@PA-5450> request chassis admin-power-o
ff slot <slot-number>
admin@PA-5450> request chassis enable slot <
slot-number>
In an HA configuration, you must install the same number and
model of NCs in each firewall and the slot numbers must match.
For example, after installing two NCs (one in each firewall), the
firewall keeps them in a disabled state until you enable them.
This allows the firewall to start HA monitoring on each NC at
the same time.
To enable NCs after inserting them into the same slot numbers
on each firewall in an HA configuration, run the following
command:
95
2022 Palo Alto Networks, Inc.
©