PaloAlto Networks PA-5400 Series Hardware Reference Manual page 64

PA-5400 Series Firewall Installation
connected to a different circuit breaker. This ensures power redundancy and allows for
planned electrical circuit maintenance.
2. Connect the other ends of the DC cables to the front of the DC power supplies by pushing
the plastic connector into the DC power supply until it clicks into place. Ensure that you
connect each pair of power supplies to a different circuit breaker.
When cabling the DC power supply to your power source, ensure that you route the
cable in such a way that it does not put pressure on the plastic clips located at the
front of the DC power supplies. It is best to route the cables first and then plug the
cables into the power supplies.
STEP 9 |
Confirm that all
STEP 10 | After each AC or DC cable is securely connected, turn on the power source and the
appliance will power on.
Before powering on the firewall, ensure that you have connected your Ethernet cables
in accordance to the mode you wish to boot the firewall in (standard mode or Zero
Touch Provisioning mode) as specified in
PA-5400 Series Next-Gen Firewall Hardware Reference
front slot cards are properly inserted.
Set Up a Connection to the
64
Firewall.
2022 Palo Alto Networks, Inc.
©