PaloAlto Networks PA-5400 Series Hardware Reference Manual page 92

Service the PA-5400 Series Firewall Hardware
STEP 4 | Grip the front ejector handles and gently pull the card out of its slot.
STEP 5 | With your replacement MPC in hand, rotate the card and align it with the front of the
appliance so that the Palo Alto Networks logo is readable at the top of the card.
STEP 6 | Gently push the replacement MPC into slot 7 until the card reaches the end of the slot. Push
on both ejector handles until they lock the card into place.
Before booting the firewall in the following step, read
Firewall
the mode you wish to boot the firewall in (standard mode or Zero Touch Provisioning
mode). The firewall will boot in ZTP mode if no action is taken.
STEP 7 |
Boot the appliance with the new MPC installed. When prompted, log in and
to factory default
STEP 8 | After the reset operation is complete, take the necessary steps outlined in
Connection to the Firewall
STEP 9 |
Restore your previous device configuration.
• (ZTP mode) Stand by as the device group and template configurations are pushed to the
firewall from Panorama.
• (Standard mode) Login and load your preferred version and configuration of PAN-OS.
PA-5400 Series Next-Gen Firewall Hardware Reference
to ensure that you have connected your Ethernet cables in accordance to
settings.
to determine your boot mode.
Set Up a Connection to the
92
reset the firewall
Set Up a
2022 Palo Alto Networks, Inc.
©