PaloAlto Networks PA-5400 Series Hardware Reference Manual page 66

PA-5400 Series Firewall Installation
STEP 1 | Using a terminal emulator, such as PuTTY, launch an SSH session to the firewall.
Run the following command:
admin@PA-5450> show chassis power
STEP 2 | View the output for information on the status of each component and the current power
rating.
For example, the following table shows the CLI output (in table format) from a PA-5450 with
three power supplies installed. The output shows each front slot (1 to 7), the installed power
supplies and fan trays, the status of each component, the rated power consumption for each
component, and the amount of power produced by each power supply. The power supplies are
labeled PS1 to PS4.
Example Power Output from a PA-5450 Firewall
Slot Component
PA-5400-BC-A
Base Card
1 PA-5400-NC-A
2 PA-5400-NC-A
3 empty
4 PA-5400-DPC-A
5 empty
6 empty
7 PA-5400-MPC-A
FANTRAY PA-5450-FAN
1
FANTRAY PA-5450-FAN
2
FANTRAY PA-5450-FAN
3
PA-5400 Series Next-Gen Firewall Hardware Reference
Card Status Power (w)
Up 195
Up 100
Up 100
Up 335
Up 152
Present 193
Present 193
Present 193
66
2022 Palo Alto Networks, Inc.
©