Service the PA-5400 Series Firewall Hardware
STEP 6 |
Gently pull the SSD away from its mating connector. Place the old SSD to the side.
STEP 7 |
Slide the new SSD into the vacant mating connector. Ensure that the SSD aligns with the
plastic standoff on the MPC.
STEP 8 |
Fasten the retention screw back into place at a torque of 4 in-lbs.
Exceeding a torque of 4 in-lbs will damage the equipment.
STEP 9 |
Before re-installing the MPC, plug the banana clip end of your ESD wrist strap into one of
the ESD ports located on the back of the appliance.
STEP 10 |
Slide the MPC back into slot 7. See
Card (MPC)
PA-5400 Series Next-Gen Firewall Hardware Reference
for more information.
Install a PA-5400 Series Firewall Management Processor
115
2022 Palo Alto Networks, Inc.
©