Table of Contents
Advertisement
AC/power precautions
Read all safety and warning guidelines before connecting to AC power.
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
•
FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
•
SHOCK HAZARD! The AC power cord must be inserted into an outlet with grounding.
•
SHOCK HAZARD! A dedicated, protected ground or earth wire must be installed on the product
by Christie qualified technicians or electricians before it can be connected to power.
•
SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
•
Install the product near an easily accessible AC receptacle.
•
Always connect the ground or earth first to reduce shock hazard.
•
A certified electrician must be present during installation to make sure the installation meets the
local electrical code.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Use an appropriately sized strain relief connector with the knockout plate provided, to make sure
adequate environmental sealing and to prevent the AC supply cable from accidentally being torn
out or rubbing against the knockout plate.
•
FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
•
FIRE OR SHOCK HAZARD! Do not overload power outlets and extension cords.
•
SHOCK HAZARD! Power supply uses double pole/neutral fusing.
Light intensity hazard distance
This projector has been classified as Risk Group 3 as per the IEC 62471-5:2015 standard due to
possible hazardous optical and thermal radiation being emitted.
Warning! If not avoided, the following could result in serious injury.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. Class 1 Laser Product - Risk Group 3 according to IEC 60825-1:2014 and IEC
62471-5:2015.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height that prevents exposure of
spectators' eyes within the hazard distance. The hazard zone must be no lower than 2.5 meters
(US installations) or 2.0 meters (global installations) above any surface upon which any persons
are permitted to stand and the horizontal clearance to the hazard zone must be a minimum 1.0
meters.
•
EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following show the zones for ocular and skin hazard distances.
Cinema 2K-RGB Installation and Setup Guide–CP2415-RGB and CP2420-RGB
020-103259-01 Rev. 1 (10-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Introduction
8
Advertisement
Table of Contents
