745Pc Software Interface; Overview; Requirements; Toolbar And Menus - GE TRANSFORMER MANAGEMENT RELAY 745 Instruction Manual

4 HUMAN INTERFACES

4.2745PC SOFTWARE INTERFACE

The 745PC software, provided with every 745 relay, allows easy access to all relay setpoints and actual values via a per-
sonal computer running Windows
• Program/modify setpoints
• Load/save setpoint files from/to disk
• Read actual values
• Monitor status
• Plot/print/view trending graphs of selected actual values
• Perform waveform capture (oscillography)
• Download and "playback" waveforms (Simulation Mode)
• View the Event Recorder
• View the harmonic content of any phase current in real time
• Get help on any topic
The 745PC software can be used "stand-alone", without a 745 relay, to create or edit 745 setpoint files.
The configuration listed is for both a minimum configured and an optimal configured system. Running on a minimum config-
uration causes the performance of the PC software to slow down.
• Processor: minimum 486, Pentium or higher recommended
• Memory: minimum 4 MB, 16 MB recommended, minimum 540K of conventional memory
• Hard Drive: 20 MB free space required before installation of software.
ADDITIONAL WINDOWS 3.1/3.11 CONSIDERATIONS
• Installation of SHARE.EXE required.
• Close other applications (spreadsheet or word processor) before running the PC software to eliminate any problems
because of low memory.
GE Multilin
Courtesy of NationalSwitchgear.com
®
3.1/95 or higher and one RS232 port (COM1 or COM2). 745PC allows the user to:
Figure 4–2: 745PC TOOLBAR SUMMARY
745 Transformer Management Relay
4.2 745PC SOFTWARE INTERFACE

4.2.2 REQUIREMENTS

4.2.3 TOOLBAR AND MENUS

Opens the Help window
Opens the Popup Currents window
Hang up
Modem Dial
Sets the communications parameters
Sends the current file to the printer
Saves the current file to disk
Open an existing file
Open a new file

4.2.1 OVERVIEW

4
4-5