Advertisement
REPLACE STUB SHAFT (CONT.)
• Replace the belt guard housing.
• Replace V-belt and align the sheaves as
instructed in the Servicing Belt Section of
this manual. Adjust sheaves as necessary to
get the proper belt alignment. Check belt
tension and set as described in Servicing
Belt section. Belt alignment and tension are
very important for long bearing life.
• Grease stub shaft bearing at the grease
fitting on the end of the shaft. Wipe off
excess grease.
NOTE: Excess grease will attract dirt.
DO NOT over grease, over greasing could
cause a hydraulic type lift on seals.
• Follow the instructions in the Machine
Maintenance section for frequency and
application of grease. Also see the
Lubrication Chart.
• Replace belt guard cover.
Never Operate Machine Without Belt Guard Covers in Place and Properly Secured.
Check All Bolts for Tightness.
SP6016
CAUTION
SERVICING STUB SHAFT
55
Advertisement
