Advertisement
TOOTH ARRANGEMENT
• Inspect pockets, teeth, and bolts for damage
and replace as required.
• When replacing pockets, always replace
new pockets across from each other in
order to prevent vibration.
• Replacement teeth must be carbide tipped
and have like design as provided with the
machine.
Opposing outside pockets carry like arrangements of teeth to cancel vibration
• Straight teeth are mounted in TWO
OPPOSING OUTSIDE POCKETS.
• A straight tooth must have a 45º tooth
accompanying it in the same pocket set.
The opposite pocket set should have
this same combination of straight and
45º teeth, except with positions
reversed. Mounting these teeth opposite
each other on the cutter wheel will
cancel out damaging vibration.
SP6016
SERVICING CUTTER WHEEL
• Use anti-seize on threads to prevent bolts
• When replacing complete set of teeth, be
• Torque bolts to 170 ft/lbs.
from "freezing up" in cutter wheel pockets.
sure to duplicate original factory tooth
arrangement.
• The TWO OTHER OPPOSING
OUTSIDE POCKETS, as shown, must
have 45º teeth overlapping centerline of
wheel to make plunge cuts possible.
Mount two left 45º opposite two right
45º teeth.
• All remaining outside pockets and all
inside pockets require 45º teeth mounted
away from wheel.
• The second pocket in each group
gradually goes back into the cutter wheel
for half a rotation and then repeats.
38
Advertisement
