Advertisement
LUBRICATION CHART
• Use NLGI Grade 2 grease or equivalent.
• Always clean tip of grease gun fitting and grease fitting on machine before attaching
hose to prevent dirt from being forced into machine parts. Note: Wipe off excess grease.
Excess grease will attract dirt.
Item
No. Item
1
CUTTER WHEEL BEARINGS
JACKSHAFT BEARINGS
2
BOOM BEARINGS
3
ENGAGEMENT LEVER
TURNTABLE BEARING
4
ENGINE SLIDE FRAME
5
STUB SHAFT BEARING
6
TRACK TENSION CYLINDER (TRX)
7
TRACK FINAL DRIVE (TRX)
ENGINE
SP6016
QTY
2
●
2
●
2
●
1
●
6
6
1
2
●
2
*
MACHINE MAINTENANCE
Comments
Purge until clean grease is seen.
2-4 Pumps with hand grease gun.
1-2 Pumps with hand grease gun.
●
100 hour increments add 3-5 pumps with
●
hand grease gun.
500 hour increments add 2-3 pumps with
●
hand grease gun.
Check tension daily, lubricate as needed.
Change after initial 200hrs. After that,
●
every 1000 hrs. or annually, whichever
comes first. Use SAE 30 CD OIL.
*REFER TO MANUFACTURER'S MANUAL
33
Advertisement
