Advertisement
REPLACE STUB SHAFT (CONT.)
• Pull stub shaft out of the bearing sleeve.
• Remove the snap ring and remove sheave.
• Inspect bearing sleeve for grooves or burrs.
Replace if needed. Note: if worn, it is
recommended to replace the complete kit
(bell housing, bearing sleeve and coupling
plate) to avoid future damage and expense!
• To remove the bearing sleeve and to access
the coupling plate, remove the bolts around
the outside of the bell housing.
*(3/8-16 x 1/4" bolt, use 9/16" socket)
• Inspect and replace any parts found
defective or worn. Replace coupling plate if
damaged.
• Prior to reinstalling the coupling plate, apply
anit-seize (coupling lubricant) to the inside
(ID) of the coupling.
• Line up external splines with the coupling
ID and slide the coupling plate into place.
SP6016
SERVICING STUB SHAFT
53
Advertisement
